[Otázka] Surface reinforcement tool doesn't work


Hello,

I would like to create a reinforced concrete wall with the area reinforcement tool, but I'm having a hard time with it...
I enter the offset (picture a1), I draw a polygon (picture a2), and after I close the polygon (or hit Esc after the diagonal was drawn) it cancels the command without any error message (picture a3).
I tried this tool in a new project, and it worked fine. I noted that the polygon is represented with only one line, the concrete cover doesn't appear.

What is the cause of the problem?

Thanks in advance!

Přílohy (3)

Type: image/jpeg
Staženo 212
Size: 240,39 KiB
Type: image/jpeg
Staženo 161
Size: 395,63 KiB
Type: image/jpeg
Staženo 172
Size: 229,42 KiB

Show most helpful answer Hide most helpful answer

Hello,

check if your model is far from the 0,0,0, if so move it closer to 0,0,0 (can use Offset cordinates in Project settings)!

Best regards.

Hello I am having the same problem, could you please tell me if you found any solution ?

Thank you in advance !

Allplan support told me that it's a model error. I couldn't find any solution...

Hello,

check if your model is far from the 0,0,0, if so move it closer to 0,0,0 (can use Offset cordinates in Project settings)!

Best regards.


https://campus.allplan.com/ používá cookies  -  Více informací

Souhlasím