Schraffur oder Füllfläche mit Rand


Hallo,

nur mal so als kleiner Tipp:
Wenn man Schraffuren, Muster oder Füllflächen mit nachgezeichnetem Rand haben möchte, kann man bis zu einem gewissen Grad das Werkzeug "Flächenobjekt" nutzen...

Gruß

Jörg

Software: Allplan, Lumion, OM by Cycot, FM by Cycot, Nevaris...
Coachings unter http://www.cycot.de / Tutorials unter http://www.allplanlernen.de

Attachments (1)

Type: image/png
Downloaded 291 times
Size: 39,96 KiB

Hallo Jörg,

das "Objekt" kannte ich noch gar nicht. Ist deine Abbruchlinie eine normale Strichart oder eine Musterlinie? In der 2019 ist für die Umrandung des Flächenobjekts keine Musterlinie möglich, ist das in der 2020 anders?

Viele Grüße
Andreas

Hallo Andreas,

das ist eine normale Linie. Kuck mal weiter unten bei den Stricharten. Da gibt es die Abbruchlinien.
Musterlinie funktioniert in diesem speziellen Fall leider nicht.

In der Datei linetype.dat kann man, wenn man sich da auskennt, Stricharten wie die Abbruchlinie auch selber definieren. Ich finde blos dazu gerade eine passende Dokumentation.

Gruß

Jörg

Software: Allplan, Lumion, OM by Cycot, FM by Cycot, Nevaris...
Coachings unter http://www.cycot.de / Tutorials unter http://www.allplanlernen.de

Attachments (2)

Type: image/png
Downloaded 105 times
Size: 44,91 KiB
Type: image/jpeg
Downloaded 94 times
Size: 208,30 KiB

Hi Jörg,
meinst du das FAQ!?

Gruß

Fredo

Attachments (1)

Type: application/pdf
Downloaded 839 times
Size: 115,35 KiB

Hi,

Danke! So was meine ich. Ich dachte noch zusätzlich an einen tiefere Beschrieb wo man die Syntax noch genauer hat um auch etwas anderes als Abbruchlinie zu definieren.

Software: Allplan, Lumion, OM by Cycot, FM by Cycot, Nevaris...
Coachings unter http://www.cycot.de / Tutorials unter http://www.allplanlernen.de

... falls du das noch finden solltest, dann wäre ich auch sehr daran interessiert!

Gruß

Fredo


https://campus.allplan.com/ uses cookies  -  More information

Accept