[Domanda] Bended Rebar shown as a single line [Risolto]


Hi,

Actually, I have solved the error display for bended bar (ties/stirrups) by change some values in the Bar Mark properties tab.
But I'm still wondering, What's causing bended bars shown as a single line?
So, we can prepare and avoid the error at the first time.

D.W.Wicaksono

Allegati (3)

Type: image/jpeg
48 scaricato
Size: 280,33 KiB
Type: image/jpeg
38 scaricato
Size: 172,70 KiB
Type: image/jpeg
37 scaricato
Size: 33,16 KiB

Show solution Hide solution

Hello,

There is sometime a display error when Allplan can't calculate the rounding of the nod in 3D. If i remember, this is belong to the bending pin diameter. If you edit it, than it's working better.

Maybe this can help.

Mr Judy GURAVADU
Responsable Technique Préfabrication & Ingénierie
Precast Sales & Support

Allplan France & Allplan Software Engineering

Depuis 2006

Hello,

There is sometime a display error when Allplan can't calculate the rounding of the nod in 3D. If i remember, this is belong to the bending pin diameter. If you edit it, than it's working better.

Maybe this can help.

Mr Judy GURAVADU
Responsable Technique Préfabrication & Ingénierie
Precast Sales & Support

Allplan France & Allplan Software Engineering

Depuis 2006

Hi judy,

You're right it's all about bending pin. As long as I remember it always happen when the bending factor is too small (in previous version of Allplan). So, it should be OK if I change it to a bigger value for bending factor (6).

Thank you

D.W.Wicaksono


https://campus.allplan.com/ utilizza cookies  -  Maggiori informazioni

Accetta