ROOF SLOPES [Решен]


Hello,
I have the problem that I can’t use the command “click edges of the roof frame to apply slopes” on a roof frame. What could be the reason for that?

Onur

Вложения (1)

Type: image/jpeg
Загружено 513 раз
Size: 32,56 KiB

Dear Onur,
If you draw two several roof frames one after another with the same plan the command “click edges of the roof frame to apply slopes” won’t work. You have to delete the roof frame and draw it again.

You’ll get 2 roof ridges and a “flat roof” if the upper edge (Z-coordinate) was chosen too small. The roof frame will be capped in that height. Otherwise the roof slopes connect at the highest point. (see pic)

best regards
Undine

Вложения (1)

Type: image/jpeg
Загружено 521 раз
Size: 37,63 KiB

Hi Undine

I have understood. Thanks for help. Now I know some more than before.

Onur


https://campus.allplan.com/ uses cookies  -  More information

Accept