Im Allplan Connect Forum tauschen sich Anwender aus, geben wertvolle Tipps oder beraten sich bei ganz konkreten Aufgabenstellungen − auch international.
Und damit wirklich keine Frage unbeantwortet bleibt, unterstützen die Mitarbeiter des Technischen Supports ebenfalls aktiv das Forum.
Melden Sie sich jetzt an und diskutieren Sie mit!
I export IFC from the same model in Allplan 2023 and Allplan 2025. I set the export settings the same in both versions. (see attached pictures) Why is it that Allplan 2023 completes the export in 2-3 minutes, while Allplan 2025 takes 45-50 minutes?
thanks for the ideas in advance
Hello, we get something this feedback about latency during export.
There was many improvement to have better data between version but we have find out that the 2D data (like 2D line, texte,...) can increase the time during the export.
In fact even if they are not export, they are check by the système.
So i will recommand you to avoid to select any 2D data on your selection.
We see sometimes project, where there more than 100'000 2D object in some drawing file. Avoid such file will reduce the export time.
If you have not select such file and still have a long time to export i will recommand you to check file per file to find out which one takes time.
It can be beacause of some defect objet.
At the end it should be similaire than before, even more faster.
HINT: the export can handle the layer selection, so if you have hide some layer, they won't be exported.
