Im Allplan Connect Forum tauschen sich Anwender aus, geben wertvolle Tipps oder beraten sich bei ganz konkreten Aufgabenstellungen − auch international.
Und damit wirklich keine Frage unbeantwortet bleibt, unterstützen die Mitarbeiter des Technischen Supports ebenfalls aktiv das Forum.
Melden Sie sich jetzt an und diskutieren Sie mit!
Hello. Allplan users.
During the rebar modeling process, I have a question, so I would like to hear from users. I am wondering if it is possible to place a spiral reinforcement on the curved part as shown in the figure below. If possible, please share the method. Thank you.
Hello, I am the user from Vietnam.
For this type of rebar, I can give you 2 suggestions:
+Create any 3D curve (have to create 3D curve in spiral shape), then you can convert that curve into rebar with Convert Feature
+Create 3D curve also, Place a straingth barshape as a point like below; then use the Sweep/Extrude along path
Basically, In the default functions, we can create common rebar in the available list.
Beyond of that, you have to convert from 3D line/ 3D curve or create automatically with Smartpart, Pythonpart or Allplan Visual scripting.
Hope that would be helpful for you.
Hello, I am the user from Vietnam.
For this type of rebar, I can give you 2 suggestions:
+Create any 3D curve (have to create 3D curve in spiral shape), then you can convert that curve into rebar with Convert Feature
+Create 3D curve also, Place a straingth barshape as a point like below; then use the Sweep/Extrude along path
Basically, In the default functions, we can create common rebar in the available list.
Beyond of that, you have to convert from 3D line/ 3D curve or create automatically with Smartpart, Pythonpart or Allplan Visual scripting.
Hope that would be helpful for you.
