Allplan Forum: Mesh

Das Wissen aller Anwender nutzen

Im Allplan Connect Forum tauschen sich Anwender aus, geben wertvolle Tipps oder beraten sich bei ganz konkreten Aufgabenstellungen − auch international.
Und damit wirklich keine Frage unbeantwortet bleibt, unterstützen die Mitarbeiter des Technischen Supports ebenfalls aktiv das Forum.

Es erwarten Sie:

Foren-Vielfalt aus CAD Architektur, CAD Ingenieurbau uvm.
Tipps von User für User
international: Deutsch, Englisch, Italienisch, Französisch und Tschechisch

Melden Sie sich jetzt an und diskutieren Sie mit!

Zur Registrierung

Forum
CAD Engineering
CAD Engineering

[Frage] Mesh

Schlagworte:

Mesh overlap

jdani

22.03.2016 - 16:50

Hello,

I have an example of mesh reinforcement (see the image). There are diferent overlaps in vertical direction betwen meshes. When I use the tool : Span reinforcement there I can define overlap in both directions(vert. and trans.), but those overlaps are fixed, the dimensions don't change. I would like to know if it is possible to define mesh where Allplan calculates overlaps by itself or I need FEM results, which I think was used in my case.

Thank you for your answer.

Danijel

Anhänge (1)

Typ: image/png

371-mal heruntergeladen

Größe: 63,11 KiB

Judy_Allpl…

14.04.2016 - 14:53

Hi Jdani,

In fact there is no automatic calculation of overlap in Allplan.

By looking on the 'cross section' catalog, you can see the minimum overlap for each kind of Meshes.

Than when you place any mesh, you will see the same value.

By the way, you can click on the icone 'Overlap' in longitudinal or cross direction to change it. Depending of your placement, Allplan will try to optimise the placement that the overlap is bigger than the minimum.

But there is no more possibility.

Thank you for your understanding.

Mr Judy GURAVADU
Responsable Technique Préfabrication & Ingénierie
Precast Sales & Support

Allplan France & Allplan Software Engineering

Depuis 2006

« Zurück