Im Allplan Connect Forum tauschen sich Anwender aus, geben wertvolle Tipps oder beraten sich bei ganz konkreten Aufgabenstellungen − auch international.
Und damit wirklich keine Frage unbeantwortet bleibt, unterstützen die Mitarbeiter des Technischen Supports ebenfalls aktiv das Forum.
Melden Sie sich jetzt an und diskutieren Sie mit!
Good afternoon.
As indicated on a smartpart
IF = g1 = "cube" then I want you to draw the cube
goto "100" tag
if = g1 = "cylindre then I want it to draw a cylinder
I'm sorry for this very basic question.
Thanks in advance
Regards
Hola Toni,
Each function have a help in the bottom of the window. Please look at this help. It can really help you.
In your case, you can do like this:
IF g1 = "cube" THEN
Hola Toni,
Each function have a help in the bottom of the window. Please look at this help. It can really help you.
In your case, you can do like this:
IF g1 = "cube" THEN
Hola Toni,
Each function have a help in the bottom of the window. Please look at this help. It can really help you.
In your case, you can do like this:
IF g1 = "cube" THEN
Hola Toni,
Each function have a help in the bottom of the window. Please look at this help. It can really help you.
In your case, you can do like this:
IF g1 = "cube" THEN
