Im Allplan Connect Forum tauschen sich Anwender aus, geben wertvolle Tipps oder beraten sich bei ganz konkreten Aufgabenstellungen − auch international.
Und damit wirklich keine Frage unbeantwortet bleibt, unterstützen die Mitarbeiter des Technischen Supports ebenfalls aktiv das Forum.
Melden Sie sich jetzt an und diskutieren Sie mit!
Hello!
Can someone tell me if i can assign each reinforcement bar (function of diameter or mark) a specific colour in 3D model (animation mode)
For example: -all ? 8 barss to be GREEN
-all ? 14 bars to be BLUE
-all ? 16 bars to be RED
All in the same model
Dear Alex,
This option is available for Allplan 2013.
In order to get colour by diameter you have to do the following settings:
Options->Animation->Representation of engineering elements->Bar reinforcement->Surface colors for diameters.
Assign Diameter colours button will be now available.
Hope it helps!
Best regards,
Ciprian
Dear Alex,
This option is available for Allplan 2013.
In order to get colour by diameter you have to do the following settings:
Options->Animation->Representation of engineering elements->Bar reinforcement->Surface colors for diameters.
Assign Diameter colours button will be now available.
Hope it helps!
Best regards,
Ciprian
Thanks Ciprian for your answer!
I managed to solve this "problem" even in Allplan 2011
i assigned manually a different layer to each diameter (this cand also be done for each mark)
and then i just set a specific colour to each layer.
Hello again,
This can be a solution but you have to be careful, because if you place identical bars on different layers and reorder the marks they won't appear as the same marks.
You can also apply filters on diameter after you finish the reinforcing and change change format-> change color.
Best regards,
Ciprian
