[Frage] Visual Scripting: Missing initial surfaces with sweep [Gelöst]

PuMaIng
PuMaIng
03.12.2020 - 13:56

Hello everybody,

i created a cross section of 3D lines, then combined them into a path (Path3D) and extruded them (SweepByPath).
So far, a 3D solid has been created. However, this is no longer the case (see pictures) and the initial surfaces are no longer created during sweep, so only 2D surfaces are created.

Does anyone know what this could be due to?

Thanks a lot

Marco

Anhänge (2)

img
2020-11-30_FailureSweep.JPG
Typ: image/jpeg
22-mal heruntergeladen
Größe: 17,03 KiB
img
2020-11-30_FailureSweep3.jpg
Typ: image/jpeg
19-mal heruntergeladen
Größe: 123,51 KiB

Lösung anzeigen Lösung verbergen

PuMaIng
PuMaIng
04.12.2020 - 11:26

Hi Ralph,

thanks for your answer. I checked it, but it was activated. Luckily I found the error by going through the links afterwards. I forgot to connect the 4 top lines (red circle) to the sweep, so the cross section was not closed and the sweep was incomplete.

Regards,

Marco

Anhänge (2)

img
2020-11-30_FailureSweep4.JPG
Typ: image/jpeg
66-mal heruntergeladen
Größe: 84,05 KiB
img
2020-11-30_FailureSweep5.JPG
Typ: image/jpeg
33-mal heruntergeladen
Größe: 14,84 KiB
pullinr
pullinr
03.12.2020 - 14:09

Hi Marco,
Can you check to see if the ClosedVolume is ticked?
Without this the Sweep function will create an open surface and not a closed volume.
Cheers!
Ralph

Anhänge (1)

img
2020-12-03_14-05-54.jpg
Typ: image/jpeg
37-mal heruntergeladen
Größe: 49,62 KiB
PuMaIng
PuMaIng
04.12.2020 - 11:26 [Lösung]

Hi Ralph,

thanks for your answer. I checked it, but it was activated. Luckily I found the error by going through the links afterwards. I forgot to connect the 4 top lines (red circle) to the sweep, so the cross section was not closed and the sweep was incomplete.

Regards,

Marco

Anhänge (2)

img
2020-11-30_FailureSweep4.JPG
Typ: image/jpeg
66-mal heruntergeladen
Größe: 84,05 KiB
img
2020-11-30_FailureSweep5.JPG
Typ: image/jpeg
33-mal heruntergeladen
Größe: 14,84 KiB