Im Allplan Connect Forum tauschen sich Anwender aus, geben wertvolle Tipps oder beraten sich bei ganz konkreten Aufgabenstellungen − auch international.
Und damit wirklich keine Frage unbeantwortet bleibt, unterstützen die Mitarbeiter des Technischen Supports ebenfalls aktiv das Forum.
Melden Sie sich jetzt an und diskutieren Sie mit!
Using reference planes on base slabs the first opening is created correctly but the second, third etc. are not punching trough the base slab.
Balázs Schneider
NAZCA Engineering Office
- first Allplan install on Interactive Unix in 1993
- 25 years in localization of Allplan
- 25 years in technical support for Allplan
Hello,
thank you for the feedback.
This problem was fixed in Allplan 2019-1.
S pozdravom | Best regards | Mit freundlichen Grüßen
Martin Mikus
Product Manager Allplan Architecture
Hi,
As you can see above I intentionally added the Allplan 2019-1 tag to the topic, because it is happening right in that version.
Balázs Schneider
NAZCA Engineering Office
- first Allplan install on Interactive Unix in 1993
- 25 years in localization of Allplan
- 25 years in technical support for Allplan
The situation is the same when you not use the Default planes for a slab. The first opening correctly uses the custom bottom and top height settings while the second, third etc. openings use the Default planes for height settings.
Balázs Schneider
NAZCA Engineering Office
- first Allplan install on Interactive Unix in 1993
- 25 years in localization of Allplan
- 25 years in technical support for Allplan
