Allplan Forum: Reference planes and openings incorrect behavior

fani

30.05.2019 - 15:18

Using reference planes on base slabs the first opening is created correctly but the second, third etc. are not punching trough the base slab.

Balázs Schneider
NAZCA Engineering Office

- first Allplan install on Interactive Unix in 1993
- 25 years in localization of Allplan
- 25 years in technical support for Allplan
- 30+ years using Allplan as structural engineer

Anhänge (1)

Reference planes and openings.mp4

Typ: video/mp4

1138-mal heruntergeladen

Größe: 3,30 MiB

MartinMiku…

04.06.2019 - 11:45

Hello,

thank you for the feedback.
This problem was fixed in Allplan 2019-1.

S pozdravom | Best regards | Mit freundlichen Grüßen

Martin Mikus
Product Manager Allplan Architecture

fani

04.06.2019 - 15:20

Hi,

As you can see above I intentionally added the Allplan 2019-1 tag to the topic, because it is happening right in that version.

Balázs Schneider
NAZCA Engineering Office

- first Allplan install on Interactive Unix in 1993
- 25 years in localization of Allplan
- 25 years in technical support for Allplan
- 30+ years using Allplan as structural engineer

fani

05.06.2019 - 13:53

The situation is the same when you not use the Default planes for a slab. The first opening correctly uses the custom bottom and top height settings while the second, third etc. openings use the Default planes for height settings.

Balázs Schneider
NAZCA Engineering Office

- first Allplan install on Interactive Unix in 1993
- 25 years in localization of Allplan
- 25 years in technical support for Allplan
- 30+ years using Allplan as structural engineer

Anhänge (1)

Typ: image/png

7-mal heruntergeladen

Größe: 26,49 KiB