Im Allplan Connect Forum tauschen sich Anwender aus, geben wertvolle Tipps oder beraten sich bei ganz konkreten Aufgabenstellungen − auch international.
Und damit wirklich keine Frage unbeantwortet bleibt, unterstützen die Mitarbeiter des Technischen Supports ebenfalls aktiv das Forum.
Melden Sie sich jetzt an und diskutieren Sie mit!
Hi,
How to make 3D surface from 4 points not in the same plane?
I need to make it, but I have this error:
Another option is to make surface in one plane, and then move needed point by Stretch Entities.
But surface will be not correct...
Kind regard,
Igors
Dear Igors,
If your 4 point are not place on the same plane than you can't use the direct tool Surface, because surface means one element of minimum 3 points.
So if you have 4 points to define and you don't now the plane definition, you can use the tool named "Three-point Canopy, Four-point Canopy".
And than you will be able to define you surface as you want, like minimum 2 triangle or more.
You can set all division to minimum 2 edge and 0% for the Sag.
With this tool, you can define a surface or a volume.
Bye & Good Use
Mr Judy GURAVADU
Responsable Technique Préfabrication & Ingénierie
Precast Sales & Support
Allplan France & Allplan Software Engineering
Depuis 2006
