Hi everybody,
I would like to dimension the floor covering and the ceiling covering in the room. How can I do this?
Thanks,
György
Hi everybody,
I would like to dimension the floor covering and the ceiling covering in the room. How can I do this?
Thanks,
György
Ok. Try to remove the check on "udate automatically" inside the section properties. It should work.
Ciao Gyorgy. You mean horizontal quote in plan?
Hi Enzo,
I don't understand exactly what you mean, but I would like to dimension the floor covering and the ceiling covering in section with vertical dimension.
Thanks,
György
Sorry Gyorgy. Now I understood. Try to use instead a point in the middle of the line the point in the angle between the wall and the slab. The snap might work there.
Hi,
unfortunately, this isn't work.
Ok. Try to remove the check on "udate automatically" inside the section properties. It should work.
Hi,
Thanks!!!!
Why should I turn off the "update automatically"?
György
Cause if you switch it the finitures become a 2d design and the snaps work. After designing your quote you switch this parameter on and you have the initial situation.