In reinforcement the horizontal text leader does not show up after placing the label.
- Forum
- CAD Engineering
- CAD Engineering
[Вопрос] Text leader appears only after moving it
Show most helpful answer Hide most helpful answer
Too large coordinates, too far from the origin point?
Mit besten Grüßen!
Jürgen
Allplan Ingenieurbau V10 bis V2025
Too large coordinates, too far from the origin point?
Mit besten Grüßen!
Jürgen
Allplan Ingenieurbau V10 bis V2025
No, it is definitely not the case.
Вложения (1)
da ist etwas weit weg ...
Namenlos gezeichnet in vollem Bewusstsein - ignorant, in eigen Augen vermutlich höflich, dennoch unhöflichst, unfreundlichst wer einen/viele vermutete - sich von alters erschließende Namen nennt.
[b]
Вложения (1)
come on, 136m can not be far
I meen the value after "dl". it shows a value about 466140m an 466km is far.
the value shows the distance between the lastpoint an the aktual position of crosshair.
create something for testing on a new drawingfile at zero.
Namenlos gezeichnet in vollem Bewusstsein - ignorant, in eigen Augen vermutlich höflich, dennoch unhöflichst, unfreundlichst wer einen/viele vermutete - sich von alters erschließende Namen nennt.
[b]
Sorry, I did not realized your big red arrows in your reply.
But if you look at my first video you can see that the "dl" value does not show the relative distance from the last point clicked.
And the distance between the clicked points is not so large.
And yes I know my part. A have already checked it in an empty drawing file.
It was perfect there, but in the real life project it fails.
The dl: value shows the distance from the global origin.
And this is so big because of the project offset.
Вложения (1)
Thank you, this was my problem, had a project with very large coordinates