20.06.2019 - 08:27
In reinforcement the horizontal text leader does not show up after placing the label.
- Forum
- CAD Engineering
- CAD Engineering
[Question] Text leader appears only after moving it
Show most helpful answer Hide most helpful answer
22.06.2019 - 10:23
*
Too large coordinates, too far from the origin point?
Gruß Jürgen
Allplan V10 bis V2024
22.06.2019 - 10:23
*
[Interventions les plus utiles]
Too large coordinates, too far from the origin point?
Gruß Jürgen
Allplan V10 bis V2024
23.06.2019 - 08:34
No, it is definitely not the case.
23.06.2019 - 10:23
da ist etwas weit weg ...
Namenlos gezeichnet in vollem Bewusstsein - ignorant, in eigen Augen vermutlich höflich, dennoch unhöflichst, unfreundlichst wer einen/viele vermutete - sich von alters erschließende Namen nennt.
08.01.2024 - Gegen Bauernsperren! -> Boykott der direktverkaufenden Bauern - kauft nicht mehr direkt bei Bauern!
23.06.2019 - 11:39
come on, 136m can not be far
23.06.2019 - 14:02
I meen the value after "dl". it shows a value about 466140m an 466km is far.
the value shows the distance between the lastpoint an the aktual position of crosshair.
create something for testing on a new drawingfile at zero.
Namenlos gezeichnet in vollem Bewusstsein - ignorant, in eigen Augen vermutlich höflich, dennoch unhöflichst, unfreundlichst wer einen/viele vermutete - sich von alters erschließende Namen nennt.
08.01.2024 - Gegen Bauernsperren! -> Boykott der direktverkaufenden Bauern - kauft nicht mehr direkt bei Bauern!
23.06.2019 - 15:26
*
Sorry, I did not realized your big red arrows in your reply.
But if you look at my first video you can see that the "dl" value does not show the relative distance from the last point clicked.
And the distance between the clicked points is not so large.
And yes I know my part. A have already checked it in an empty drawing file.
It was perfect there, but in the real life project it fails.
24.06.2019 - 07:57
The dl: value shows the distance from the global origin.
And this is so big because of the project offset.
13.05.2020 - 11:55
Cité par Allplan_er
Too large coordinates, too far from the origin point?
Thank you, this was my problem, had a project with very large coordinates