I did some changes in the reinforcement and clicked the button rearrange bars
and this happened (see the picture below), the marks from the full schema dissapeared!
What causes this kind of problem?
and this happened (see the picture below), the marks from the full schema dissapeared!
What causes this kind of problem?
Quote by BogdanCucosI did some changes in the reinforcement and clicked the button rearrange barsand this happened (see the picture below), the marks from the full schema dissapeared!
What causes this kind of problem?
Can you share your file?
Did you copy marks (dissapeared marks) from sections ?
I really don't understand what you mean by copy marks from sections
Hello,
is the attached drawing file the correct one? I don´t see here the same as in the attached picture, and the function "rearrange marks" run correctly.
What´s happened, if you create a new full schema and uses then again the "rearrange marks" ?
Best regards
Michael
Michael Theuer
Customer Success Manager
Allplan GmbH
It helps for a while , then sometimes the problem occurs again
I want to know what caused it because the problem appeared on other drawings as well.
And we are currently are working on a very big project, so yeah lot of wasted time to rearenge the full schemas
Kann mich mal einer aufklären, welche Funktionen dabei verwendet werden?
Wo gibt es den die Funktion "Markierungen neu anordnen"?
Mit besten Grüßen!
Jürgen
Allplan Ingenieurbau V10 bis V2025
Guten Morgen Jürgen,
die Funktion "Verpositionieren" ist hier mit "rearrange marks" gemeint......
Michael Theuer
Customer Success Manager
Allplan GmbH
